Re: What are those!!
I went the LACK enclosure route... and it was shit... for stability and vibration. It's probably not bad if you have it sitting on a table and have a LACK just covering it... but double stacking a LACK and putting a printer on them, is no good IMHO.
best bet is to start with a table that is level with all feet squarely on the ground and go from there.
my .02
Andy
Yup, I'm really happy I set my printer up on a really solid desk first. I purchased the lack and the prints were noticeably worse, very noticeably, by the end of the day the printer was back on my desk and the Lack tables are in the pile of stuff for one of my kids to take to college... Had I went with the Lack first I wouldn't have known any better. I'm really surprised the Lack tables are as popular as they are.
Re: What are those!!
@chad.g4 Can you please share update and feedback on your feet?
Re: What are those!!
Here's my lack setup for those who want to see:
https://imgur.com/a/CXEmC
It's with a monoprice select plus, and I did find it helps in a lot of ways, but in hindsight it could be because of the ~8kg of filament and ~???kg of desiccant all sitting on top, weighing it down...
Maybe we would have better luck with Lack enclosures with a paver on top?