Notifications
Clear all
Slic3r Stange behaviour
Hey guys
Hope someone can help / explain the strange behaviour what I am experiencing.
I have seen on some very easy rectangle what I have printed some "ghost" lines where nothing is close to that this lines should appear.
So I printed a simple "cube" (perimeter = 1, infill = 0%) to see what happens.
In the picture you can see the slic3r preview and the related G-Code.
At layer change the printer moves up, then 5mm forward on X, starts printing back to the correct position and starts from there to print normally. So basically said, this 5mm are printed twice on each layer.
Does someone know what happens here?
Posted : 30/12/2017 3:00 pm