Notifications
Clear all
problem with the bed and first layer
I have a problem with my bed. No it's not bedbugs. I have re-calibrated my first layer several times and and now it stands at -730. My first layer failed again toward the back of the bed. After running calibration once more I noticed that there is a definite right to left and front to back issue. The left side is too low while the back and right side too high. What to do?
Posted : 18/02/2018 4:35 pm
Re: problem with the bed and first layer
I have the exact same issue. If I fail it is almost always are the right front. Don't know why? I get over this by making sure I clean the bed very well in alcohol. It seems help but it is not consistent by any means and if I do have a failure is always is the front right no matter which side I flip the PEI sheet too. Cleaned with Acetone did not help.
Posted : 18/02/2018 5:48 pm