New MK3 assembled, 1st layer thoughts?
Hello there, i'm Giorgio from Italy and i've happily received my first 3d printer kit past week and i assembled it over the weekend with much fun and happiness using the spot on online documentation.
The printer itself got tested and calibrated on the first try so i ended up testing some prints and playing with z adj, to nail the 1st layer the best i could.
That's the result so far, does that looks fine enough to you?
Re: New MK3 assembled, 1st layer thoughts?
which slicer did ya use? Or is that already on the card?
Re: New MK3 assembled, 1st layer thoughts?
Looks pretty good to me. But I'm only slightly more than a n00b.
Re: New MK3 assembled, 1st layer thoughts?
which slicer did ya use? Or is that already on the card?
That’s one of the bundled designs into the Sd
Re: New MK3 assembled, 1st layer thoughts?
Check out the intro video at the 8 minute mark. You could dial in our live z lower to get a smoother bottom layer if that is what you are going for?