Notifications
Clear all
MK3 Heat bed Flir Pictures
These photos were taken for my interest in just seeing how evenly the heat bed heats the entire build sheet. I have not had any issues nor any complaints...just for fun.
Here a three thermal pictures taken with a Flir E4 handheld camera.
All pictures taken with heat bed set to 60 degrees C. The extruder motor with 15 minutes of runtime.
Heat bed with build sheet in-place and taken off to show the heat bed only.
Not sure why the heat reading is higher than the scale on the bottom picture. I will retake a few more pictures to verify these shots.
MK3 Kit, Designed, built 4x4 CNC Plasma Cutting Table, Motorcycles Bigdogbro's Adventures
http://www.youtube.com/channel/UC5djrxBeeOKB9_6rHnn6G8A
Posted : 09/03/2018 12:31 am
Re: MK3 Heat bed Flir Pictures
Wow, that's pretty damn consistent!
Posted : 09/03/2018 3:15 am