Avisos
Vaciar todo
Página 2 / 2
Anterior
Re: [Guide] Mounting a Raspberry Pi 3 for Octoprint
Going to try this, as I just had a 2 day print killed by the extruder spiral wire bundle unplugging the USB cable. I was able to save it by reprinting the last cm of the print separately and gluing it on. Not cool...
Would also like to know what extra functionality using GPIO to connect to Einsy board gains. There's a reason to enable it through the printer, right?
_Erik
Respondido : 17/11/2018 9:54 pm
Página 2 / 2
Anterior