First and second layer problems
Hi,
I have had my printer for a couple months with everything working. Then I updated it and now is prints the first and second layer with like scraps or scratches. I tried messing with the z height and recalibrating, but its not helping.
Re: First and second layer problems
Did you re-calibrate your Live-Z? The previous setting may have been lost during the update. It looks like your Live-Z settings is too low (too negative) and snagging the filament. I'd suggest recalibrating your printer (the "life adjust" method is recommended).
and miscellaneous other tech projects
He is intelligent, but not experienced. His pattern indicates two dimensional thinking. -- Spock in Star Trek: The Wrath of Khan
Re: First and second layer problems
I've tried messing with the live z calibration, it's on -597. It still scrapes at like -500 and doesn't stick to the bed higher than that. Where is the life adjust?
Re: First and second layer problems
look for the V6.1 files on the first page
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
Re: First and second layer problems
Cool thanks I tried this and it looks better. I'm at -535, but there are still little gaps on one corner and the other looks fine. Do I keep going lower or is the bed unlevel.