Clicking printhead - filament stuck?
a 3D printing noob here:
I assembled my mk3 kit and did some test prints which turned out great.
The last three prints I did however failed completely.
The prints fail whenever my printhead starts making a clicking noise, and not enough material is being extruded.
I clipped the filament and noticed the filament 'pops up' again and again. I made a short clip of it (first ten seconds it's a bit blurry):
Re: Clicking printhead - filament stuck?
I have the same Problem. Do you have fixed your Problem?
Best regards
Ottmar
Re: Clicking printhead - filament stuck?
Do you have a partial clog or just the filament extruder kicks & clicks? I do not see a link to your clip.
[...] The prints fail whenever my printhead starts making a clicking noise, and not enough material is being extruded.
I clipped the filament and noticed the filament 'pops up' again and again. I made a short clip of it (first ten seconds it's a bit blurry):
and miscellaneous other tech projects
He is intelligent, but not experienced. His pattern indicates two dimensional thinking. -- Spock in Star Trek: The Wrath of Khan