Notifications
Clear all
bed leveling failed, sensor didnt trigger
getting this fault randomly when starting a print. i ran the z calibration before and it fixed it. happened this morning again. reran the z calibration and it probed all the points successfully. theres nothing on the nozzle or sensor, and the sensor light turns off when close to the bed during z calibration. but when it first goes to home the z(at the start of a print), it seems like it doesnt go far enough to the bed to trigger the sensor and gives this fault message on the lcd, requests a reset.
Posted : 26/12/2017 4:37 pm
Topic starter
answered:
Re: bed leveling failed, sensor didnt trigger
i just ran the XYZ cal, and it seems to be homing properly now.
Posted : 26/12/2017 5:37 pm