Notifications
Clear all
Reminder to choose an extruder?
Is there any way to make the MK2-MM beep, click, or otherwise make a noise as a reminder to choose an extruder in single mode? I print a lot with PETG, and it takes a bit to heat the bed to 90°C...so sometimes I forget to choose an extruder whilst doing something else. Thought it might be nice if there was an audible reminder or something when the bed was ready and an extruder needs to be selected. Thanks!
Posted : 20/09/2017 2:44 pm
Re: Reminder to choose an extruder?
I put this in my Start GCODE in Slic3r PE to do exactly that...
M300 S300 P800 ; beep
I put it right before T?. I can't take credit for it however as I found it elsewhere, I think somewhere on the Slic3r PE Github page.
Posted : 20/09/2017 10:04 pm