Notifications
Clear all
What causes this imperfection?
Hi All,
I printed this headphone holder from the PRUSA library using the g-code ( https://www.prusaprinters.org/prints/10985-tall-headphone-stand/files ). I have an I3 MK3 and I am using Hatchbox PLA Filament that has been sitting in 50% humidity room for about a year. It is a large print and most of it is fine, but one end has a lot of bumps, but only in some places. I print some other things with a different filament that were nearly as large and did not see any bumps. Any ideas?
This is the orientation during the print:
These are the bumps but only in some areas.
This end is fine:
This topic was modified 5 years ago by rletulle
Posted : 24/04/2020 9:12 pm