Notifications
Clear all

Layering issue  

  RSS
Gustafa
(@gustafa)
Active Member
Layering issue

I could really use some insight as to what makes this happen.

Both of these prints have the same issue and bear with me describing this. I hope the pictures help it make sense.

Anytime there’s a stl that prints up to a height that then requires a solid across it, the printer sort of over prints that layer off the edges.

Is this due to a belt issue, a retraction setting at that layer, I can’t figure out what causes this. Thanks for your input. (sorry for image orientation)

Posted : 20/12/2019 3:30 pm
Share: