Notifications
Clear all
Inconsistant texture on frist layer
I've been getting some inconsistencies on the first layer of a larger diagonal print. Here are a couple of pics of a tap handle I printed. It's usually in the middle of the bed but looks better closer to the sides.
This is hatchbox PETG, with the prusament profile. Prusament behaves the same way. Any thoughts?
Posted : 28/07/2021 5:23 pm
Revisit your first layer Z calibration.
You are a fraction too low; very carefully reduce the negativity, you are very close so baby steps are in order.
Cheerio,
Posted : 28/07/2021 6:34 pm