Notifications
Clear all
FlexFill 98A problem: half of model is "wonky" but generic TPU works fine
LEFT: Generic TPU using the generic TPU preset in Prusa Slicer.
RIGHT: Same model using FlexFill 98A with the FlexFill 98A preset in Prusa Slicer.
I don't know enough to realize what went wrong or how to fix it. Any ideas?
Posted : 24/09/2020 6:44 pm
RE: FlexFill 98A problem: half of model is "wonky" but generic TPU works fine
Print it again and watch it printing. Such a big deformation will be pretty visible during print.
Common issues are speed and cooling issues but seeing this picture it's hard to guess. Especially why it's started to deform at 2/3.
Often linked posts:
Going small with MMU2
Real Multi Material
My prints on Instagram
Posted : 24/09/2020 6:57 pm
treedee liked