Notifications
Clear all
First print in vase mode
I was trying to print a statue of a girl in vase mode. everything looks fine tiil the shoulder part.
Also in the back seems to be a few scars. see the pictures.
I've tried to put pictures in the message but I can't get it to work.
https://drive.google.com/file/d/1jbPVHWUJ6mc-g4xIAhrIo-fHmO4vIG-b/view?usp=sharing
https://drive.google.com/file/d/1izIhoss6G8Pc8SLgopTpMIT1o-_Nh247/view?usp=sharing
Posted : 12/02/2021 1:08 pm
RE: First print in vase mode
Couple of thoughts.
Flat top surfaces will not render well or sometimes at all in vase mode.
The shoulders are very steep. Try increasing your layer height, adjusting your extrusion width, and possibly increasing extruder multiplier by .1 or so to increase how much plastic is put out - the gaps are due to steep slope.
Posted : 12/02/2021 4:47 pm