Notifications
Clear all
Extruder Cover Not Printing Well
I am a new owner of the Original Prusa i3 MK3S, so not very experienced, yet. My first prints turned out surprisingly well, and I decided to print some critical back-up parts before disaster strikes and I need replacements in a hurry. I started with the R4 printable extruder parts using black PETG from eSun and the recommended print settings (0.2mm layer height and 20% GRID infill). Most of the parts came out fine, but the extruder cover has a hole in a thin flange and is quite weak. I tried printing just the extruder cover again, and it has the same hole in the flange (both are pictured below). Any idea what I am doing wrong?
Posted : 11/04/2019 12:51 am