Notifications
Clear all
Complicated 1st layer problem
This is the bottom side of an Raspberry Pi/Octoprint case. ( https://www.thingiverse.com/thing:3852672 ). My 1st layer has been pretty decent up until now (or so I think). Can someone help me identify what is going wrong here?
Posted : 25/08/2020 5:42 pm
RE: Complicated 1st layer problem
Someone with more knowledge might have a better solution, but from the looks of it the first layer calibration is a smidge too high. If this was my print I would clean the textured bed with IPA then run the first layer calibration to get a good first layer.
https://help.prusa3d.com/en/article/first-layer-calibration_112364
Hope it helps 🙂
Posted : 25/08/2020 11:40 pm