Notifications
Clear all
Adjust ironing after nozzle change
Hello everyone
first post here, but been hanging around for a handful of months. Ive finally decided to change out my nozzle to a hardened .6 from Prusa. Ive changed settings in the slicer, and I have re-cal'd my Z, using the post I found here(I don't have the link handy, will update). My question for the class, should there be a need to change the ironing settings, after a nozzle change? Ive been doing a lot of test prints and it seems that the Flow Rate needs to be higher, by a lot! is this right?
Posted : 03/08/2023 1:54 pm
Topic starter
answered:
RE: Adjust ironing after nozzle change
First print after nozzle change
Test Print
Was able to get it to look like this, but with Flow Rate @ 55%
Another print
Posted : 03/08/2023 2:48 pm