Notifications
Clear all
Z Step Adjustment (M503-M92?)
What is the recommended way of adjusting Z Step on the Prusa? On one of my printers, multiple calibration tests have resulted in a 1% over-size on the Z axis. So a 20 mm cube, prints a 20.2 height. On tother machines I would adjust the Z Step with an M92.. Is the same recommended procedure on the MK3S?
Posted : 13/09/2019 5:16 am
Topic starter
answered:
RE: Z Step Adjustment (M503-M92?)
Already done .. modifcation accepted .. testing new cube ..
M503
-- M92 X100 Y 100 Z400 E280
M92 396
M500
M503
-- M92 X100 Y 100 Z396 E280
Running new calibration cube test now
Posted : 13/09/2019 5:39 am
Topic starter
answered:
RE: Z Step Adjustment (M503-M92?)
Worked perfectly .. 19.98-20.3 ..
Posted : 13/09/2019 6:34 am