Notifications
Clear all
Thermal Anomaly challenges
MK3S+ (bought second hand from print farm)
Firmware: 3.14.1
I suspect they were selling it because they were having the same problems.
I replaced the thermistor and the print fan, but the problems continue. Oddly, I can get 4 hours into a 5 hour print before it crops up for the first time. Tonight, I was about 1 hour into a 3 hour print. I've double checked that the thermistor wires are above the heater wires. Still, it beeps at about 6,000 decibels and pauses. Fortunately, I can resume it since I'm printing from an SD card.
What else can I look at to rid myself of this pain?
Publié : 29/04/2026 4:49 am