Notifications
Clear all

Strange bulge on print  

  RSS
macc
 macc
(@macc)
Active Member
Strange bulge on print

Hi, I'm trying to print pasta dispenser but on side is strange scary or bulge. My suspect that Slic3r is doing something wrong... or my settings are incorrect.
Has anybody any idea how to solve this problem ?

Posted : 06/11/2018 12:05 pm
Neal
 Neal
(@neal)
Reputable Member
Re: Strange bulge on print

First guess is zipper line. You can see where the "bulge" is outside the line in the spots that the line is interrupted.

Hope that made sense,

Neal

Posted : 06/11/2018 2:52 pm
macc
 macc
(@macc)
Active Member
Topic starter answered:
Re: Strange bulge on print

Next photo... spiral defect on all surface

Posted : 06/11/2018 3:44 pm
macc
 macc
(@macc)
Active Member
Topic starter answered:
Re: Strange bulge on print

I guess, maybe it's "retract on layer change" setting ? I will try later without this parameter enabled.

Posted : 06/11/2018 4:44 pm
Mustrum Ridcully
(@mustrum-ridcully-2)
Honorable Member
Re: Strange bulge on print

Perhaps try printing in vase mode? I have added it to my to be printer pile with a note to try it in vase but it may be several weeks till i get to it.

Posted : 06/11/2018 5:47 pm
Share: