Notifications
Clear all

Start Print With One Mesh Leveling?  

  RSS
Alomex
(@alomex)
New Member
Start Print With One Mesh Leveling?

Hey I got a question which I did not found.
I always thought that doing a mesh leveling before every print is quite redundant and I'm thinking WHY we need to redo the mesh leveling everytime.
Anyone have a full argument on this?

Posted : 09/05/2018 11:27 pm
stahlfabrik
(@stahlfabrik)
Honorable Member
Re: Start Print With One Mesh Leveling?

That is easy: with changing the current temperature of the PINDA sensor (it changes "constantly"), your bed level changes. See temperature calibration

https://shop.prusa3d.com/forum/hardware-firmware-and-software-help-f64/1st-layer-problems-in-depth-look-at-software-pinda-t14815.html

So if you would also not home Z, you MIGHT get away with one - but why even bother?!

Posted : 10/05/2018 12:08 am
Share: