Notifications
Clear all
PTFE Tube Filament Jam
I just cleared a blockage where filament became jammed in the PTFE tube.
My question is the tube safe to put back in my printer temporarily as it now has exterior marks. I have tested it with a piece of filament and that runs through smoothly.
Regards
Martin
Martin Wolfe
Posted : 07/06/2018 2:56 am
Re: PTFE Tube Filament Jam
If you don't have a replacement use what you have...
Regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility.Location Halifax UK
Posted : 07/06/2018 12:36 pm