Prusa i3 MK3 now functioning after firmware upgrade
Hey everyone!
So I have 2 i3 mk3 printers and both were working absolutely fine before the firmware upgrade. So when I flashed the new firmware 3.14.0 on both the printers, the flashing was successful one printer and not the other one, but both printers stared acting weird. The temperature range for PLA was changed to 215/60 on both the printers and the filament keeps leaking before the printing starts. I calibrated them again but it did not help. I switched back to the older firmware on 1 printer but that also did not solve the problem. I tried changing the temperature while printing but it keeps going back to 215 and also goes over the specified limit. Thank you for your help in advance!
RE: Prusa i3 MK3 now functioning after firmware upgrade
This the error message and the log file Error Flashing