Avisos
Vaciar todo
print problems
I am having intermittent print problems. I did 4 long prints without any issues. I set a print to start all was good until it got to about 75% and then shifted 20mm to the right. See photo. It has also done and auto home and the nozzle crashed into the bed and put 3 nozzle marks in the FWD right corner. I have a MK3S printer with 3.5.3. version firmware. Can anyone help?
Respondido : 22/02/2019 1:55 pm
Re: print problems
No pictures in your post.
I think you may need three posts before it shows up.
see pic below. If so, reply to this post and I will reply back and you reply back again and then you should be good to post the pic... otherwise see the pic below.
Strange women, laying in ponds, distributing swords, is hardly a basis for a system of governance!
Respondido : 23/02/2019 1:19 am