Notifications
Clear all
Pause & Resume Issue
I did a little searching before starting this and I didn't find anything.
So, im on the latest firmware and slicer (of 11/01/22).
Mid way through a fairly critical PC print I had to pause the print through the display interface, I sorted my niggling issue, hit resume and then the extruder carried on with the print without resuming to the correct Z height. So without pulling my hair too hard, I restarted the print and during the brim print (just to see if it was a fluke) I paused the print, to which the same issue occurred.
My plan is to do a firmware flash and move on... but ugh damn.
Posted : 11/01/2022 10:41 pm