Notifications
Clear all
MK3S first layer prints perfect, then stops extruding. Help!
Fired up my printer after a while and the first layer goes down fine. Then it stops extruding. It doesn’t always happen, but very often. I upgraded to firmware version 1.10.0 to see if it’ll help but it still persist. Any advice?
Napsal : 02/10/2021 7:35 pm
Try adjusting the Extruder Idler screw, the screw at step 34 on this page:
https://help.prusa3d.com/en/guide/5-e-axis-assembly_169235
Cheerio,
Napsal : 03/10/2021 12:28 am