mid print Peep and asked to pull the fillement and back in
Hi, i dont know what this is... in middle in the print it stops random 1% 6% 80% and beeps... and keeps doing that until i press the knob.. display says pull the filament.. then insert filament... and it will go printing again...
so annoying.. i dont know if this is after the firmware update... can someone help me out?
RE: mid print Peep and asked to pull the fillement and back in
The usual suspects:
- inadvertently inserted color swaps in PrusaSlicer. As this seem to happen randomly, not likely.
- the filament sensor thinks you've run out of filament. You can check the Prusa knowledgebase for relevant troubleshooting advice, eg https://help.prusa3d.com/article/ir-filament-sensor-troubleshooting-mk2-5s-mk3s_112226
Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...
RE: mid print Peep and asked to pull the fillement and back in
I think as I can see where the metal ball is going in is worn out. So I enlarged the thin in the pinda.
where can I find those parts to print again and replace it?
I have the 3s
RE: mid print Peep and asked to pull the fillement and back in
The vid of the problem
RE: mid print Peep and asked to pull the fillement and back in
where can I find those parts to print again and replace it?
https://help.prusa3d.com/article/printable-parts-for-original-prusa_1824
Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...
RE: mid print Peep and asked to pull the fillement and back in
Thanks