Notifications
Clear all
Load filament doesn't advance the filament, so its not loaded, and nothing prints
My MK3S+ is about a year old, and has been working great until recently. These days, the "load filament" (or is it autoload filament?) doesn't do the full job. It says to insert the filament and press the knob, and it goes into a heat cycle. But when the set temperature is met, the extruder doesn't push the filament out.
And the firmware doesn't ask if the color is right? Y/N
FIRMWARE 3.13.2, I could upgrade to 3.13.3 if folks think that helps.
My MK3S+ has the filament detector and I know it works, because Octoprint complains when the filament runs out, gets tangled, etc.
Posted : 29/03/2024 11:44 pm