Notifications
Clear all

[Solved] Issue setting up Z axis during Wizard procedure  

  RSS
jdenver
(@jdenver)
Active Member
Issue setting up Z axis during Wizard procedure

Hi Ive got issues with the Wizard. During running the XYZ finishes ok, the head only rises about 5mm, the printer then asks me to refit the steel sheet, on doing this the nozzle then crashes into the bed and I have to reset the machine. Any ideas why this would happen.

Ive had the machine printing before (yesterday) and I updated the firmware this morning to 3.13.0-6873. Its the MK3S+ and was kit built

Posted : 02/09/2023 2:33 pm
jdenver
(@jdenver)
Active Member
Topic starter answered:
RE:

Solved. Downgraded to 3.11.0 and all's well.

Posted : 03/09/2023 2:35 pm
Share: