Notifications
Clear all

Installed latest firmware...  

  RSS
ShuhDonk
(@shuhdonk)
Active Member
Installed latest firmware...

After installing the latest firmware yesterday on my mk3s when it goes to print and does the 9 point bed calibration it is not centered, meaning the first point is all the way to the left edge, the center point is no longer center, but shifted to the left and same with the right side calibration points, all shifted to the left an inch or two.  This by design or do I need to re setup something?  I redid the xyz calibration and the first layer calibration but made no difference.

thanks!

 

Posted : 21/05/2019 4:18 am
JoanTabb
(@joantabb)
Veteran Member Moderator
RE: Installed latest firmware...

Could the revised positions be due to dodging the magnets which hold the bed in place?

I am using an order  version of firmware. I think it's 3.7.0.

 Regards Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Posted : 21/05/2019 8:19 am
Share: