HEATBED THERMAL RUNAWAY but I just installed a new OEM Thermistor. Suggestions..
 
Notifications
Clear all

HEATBED THERMAL RUNAWAY but I just installed a new OEM Thermistor. Suggestions..  

  RSS
MegardStudio
(@megardstudio)
Eminent Member
HEATBED THERMAL RUNAWAY but I just installed a new OEM Thermistor. Suggestions..

Well that didnt fix it.

I preheat for PETG, and watch the temps. Nothing is moving (bed or hotend) and I'm watching the bed temps very slowly drop starting at 85* and over about 5-10 minutes it dropped to the high 50's. I tried moving the print head around and the bed and it's still just slowly dropping so I don't think it's wires.

It just hit 54* and errored out again.

Any clue? Is it the bed or the Einsy RAMBo board or what?

 

Posted : 10/11/2023 3:53 am
MegardStudio
(@megardstudio)
Eminent Member
Topic starter answered:
RE: HEATBED THERMAL RUNAWAY but I just installed a new OEM Thermistor. Suggestions..

Anyone, ... Im out of ideas...

 

Posted : 10/11/2023 9:37 pm
Hello
(@hello)
Noble Member
RE: HEATBED THERMAL RUNAWAY but I just installed a new OEM Thermistor. Suggestions..

 

Posted by: @megardstudio

Anyone, ... Im out of ideas...

 

Ok could you video you preheating it and if you have a hairdryer video one with that blowing on it.

Please help me out by downloading a model it's free and easy but really helps me out https://www.printables.com/@Hello_474427/models

Posted : 10/11/2023 10:46 pm
MegardStudio
(@megardstudio)
Eminent Member
Topic starter answered:
RE:

Nevermind, it was a loose screw on the heatbed. 🙄

This post was modified 12 months ago by MegardStudio
Posted : 10/11/2023 11:23 pm
Hello
(@hello)
Noble Member
RE: HEATBED THERMAL RUNAWAY but I just installed a new OEM Thermistor. Suggestions..

 

Posted by: @megardstudio

Nevermind, it was a loose screw on the heatbed. 🙄

Oh, OK what screw if you don't mind me asking 

Please help me out by downloading a model it's free and easy but really helps me out https://www.printables.com/@Hello_474427/models

Posted : 11/11/2023 8:26 am
MegardStudio
(@megardstudio)
Eminent Member
Topic starter answered:
RE: HEATBED THERMAL RUNAWAY but I just installed a new OEM Thermistor. Suggestions..

The one that connects the power to the heatbed. Locknut and all it was loose. Never seen that on any of my printers. 

Posted : 11/11/2023 10:45 am
Share: