Notifications
Clear all
Have to run first layer calibration after every print
My MK3S+ is fine for about 4 or 5 hours worth of prints, but after that, the extruder seems to drop to where it's pretty much touching the build plate (or the print, if I'm attempting something that takes more time than that). It's really annoying having redo the first layer calibration every day.
Posted : 31/12/2022 9:19 am
RE: Have to run first layer calibration after every print
Have you tried securing the screw that holds the PINDA sensor in place?
Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...
Posted : 31/12/2022 12:00 pm