Notifications
Clear all
First layer issue after MMU2 to MMU2S upgrade
Hey all,
So I just completed my MMU2S upgrade, it all went pretty well. I did a z-axis calibration, and started doing first layer adjustments.
I think it started at -0.300, and I kept retrying all the way to 0.000. At that level, I think the layer thickness looks correct according to the documentation, but there are gaps between rows, like there is not enough filament extruding.
Is there anything about this upgrade that would have changed the extrusion rate? Anything else I should check?
Thank you!
Posted : 26/05/2019 1:00 am