RE: eSun PLA+ and PETG Profiles
Hello,
i am new in this forum and was searching the Internet for a Prusa Profile for the "ESun PLA+" filament, when i stumbled upon this thread. I have only 3 years of experience with 3D printing and mainly used Herz, ninjatek and amazon basics filament.
Which all worked great for me, but now i wanted to try eSun because of the good reviews i´ve found. I ordered 2 spools to print the Tintin moon rocket i´ve found on Printables.
I´ve found a PDF file on the ESun Webpage, with all their recommended settings for different printers and filamentcombinations, including the MK3S+ which i use.
I thought i should share it with you, here is the Link:
https://www.esun3d.com/uploads/eSUN-Fast-filaments-print-parameters.pdf
RE: eSun PLA+ and PETG Profiles
I had some extruder skipping, when I wanted to print it with prusament pla or generic pla settings. Had to rise the temperatur to about 250°C +/- 5°C (depends on first layer or other layers) I have some minimal stringing with this temperatures.
Also I had some weird "popping" noise for about the first 15min of printing. Thought about wet filament but it was a fresh roll out of the bag. I had this popping with 2 different colors. White and Olive Green, the white was a refill.