Can't finish wizard X axis can move using manual controlls - Hardware, firmware and software help https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-hardware-firmware-and-software-help/cant-finish-wizard-x-axis-can-move-using-manual-controlls/ Prusa3D Forum Discussion Board en-US Thu, 11 Jun 2026 19:56:38 +0000 wpForo 60 Can't finish wizard X axis can move using manual controlls https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-hardware-firmware-and-software-help/cant-finish-wizard-x-axis-can-move-using-manual-controlls/#post-223532 Fri, 19 Jun 2020 10:15:10 +0000 Hi all,

I can't finish the wizard when I start my printer, the X motor moves once and the entire wizard stops saying it X axis test failed. I thought it would be the motor but if I skip the wizard and go manually move it using the menu controls I can move it. What should I do?

THanks

]]> Hardware, firmware and software help Chicken https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-hardware-firmware-and-software-help/cant-finish-wizard-x-axis-can-move-using-manual-controlls/#post-223532