Notifications
Clear all
Calibration Errors After Printing
Hi,
I have been running my printer for quite a while without errors. I had a failed print the other night and since then my printer was unable to start a new one. It would fail during the home check. I tried to run the calibration but the X-Axis fails instantly when traversing to the left. (after hitting the far left stop it immediately indicates a failed test with an "X-Axis Length Error").
When I manually move the extruder left to right it feels like there might be a little "chop" when it gets close to the far left stop.
Any advice? or would I be better off fully disassembling the whole thing and re-assembling?
Publié : 23/05/2026 11:37 pm