Notifications
Clear all
Page 2 / 2
Prev
Topic starter
answered:
Re: Bunk rods still an issue?
New rod is on the way! 🙂
I only swapped the top two X bearings as the bottom one can't be replaced without disassembling the cable bundle. My X now seems a lot quieter, and while I haven't done any rigorous tests, I don't see any difference in print quality at the moment.
Posted : 04/03/2019 4:13 pm
RE: Bunk rods still an issue?
I have the same Problem with the Bearings on my MK3s
I have orderd new bearings in the Prusa3d shop an will replace the Bearings at this weekend
Posted : 11/10/2019 8:56 am
RE: Bunk rods still an issue?
@randolph-l
Fantastic info even a year later. Just that for which I was looking
Posted : 16/02/2021 12:33 am
Page 2 / 2
Prev