What Could Be Causing This? Is This Layer Shifting?
I've been having trouble getting good prints. I have lubed the rods and ran the calibrations... all the axis and pulleys seem to be fine.
I printed this with an MMU2S and soluble filament for the interface layers.
The surface should of course be smooth... but it has this striped pattern. The layers keep shifting back and forth a bit? When I look at photos of what layer shifting is though, this does not seem to be it. Or am I wrong?
If anyone knows what I can do about this, it'd be greatly appreciated.
RE: What Could Be Causing This? Is This Layer Shifting?
Nevermind everyone, before you put time in answering this, I'll first go through _everything_ on this page: https://www.help.prusa3d.com/en/article/layer-shifting_2020 and I'll update accordingly. Sorry for asking the question too prematurely. But I might be back! 😀