Switched from standard grey PRUSA filament to "Gentlemen's Gray" and now print failures
 
Notifications
Clear all

Switched from standard grey PRUSA filament to "Gentlemen's Gray" and now print failures  

Stránka 2 / 2
  RSS
Simplexify
(@simplexify)
Active Member
RE: Switched from standard grey PRUSA filament to "Gentlemen's Gray" and now print failures

@cwbullet

Have you tried that specific filament? Because I'm not complaining about the acetone part (once in three years isn't that bad) but rather the fact that it is required to get that specific filament to stick to the bed when all others have been sticking easily with a 90% IPA wash. I might have hit a bad roll but since at least another buyer has had trouble, I'm starting to think it might have to do with the color it self.

Cheers

Napsal : 03/12/2020 10:01 pm
cwbullet
(@cwbullet)
Member
RE: Switched from standard grey PRUSA filament to "Gentlemen's Gray" and now print failures

I have tried it.  I had a tough time.  

--------------------
Chuck H
3D Printer Review Blog

Napsal : 03/12/2020 11:13 pm
Simplexify se líbí
Stránka 2 / 2
Share: