Notifications
Clear all
Lots of lines in the middle of a printed cylinder pipe
Hello, I printed a cylinder pipe using PLA. I noticed that there are lots of lines running across the inner of the cylinder. Is this caused by stringing? How to prevent this from happening again? For the one I already got, what is the best way to get rid of them? Tried to use fingers but they are not that easy to remove.
Posted : 20/05/2023 7:06 pm
RE: Lots of lines in the middle of a printed cylinder pipe
Maybe a picture would help to understand your problem.
Best regards, Clemens
Mini, i3 MK2.5S, i3 MK4, CClone (Eigenbau)
Posted : 21/05/2023 3:30 pm
Razor liked