FW3.3.0-830 - Does not recover from power failure
I've had trouble with resuming prints after power outages since FW3.2.0. Prior to that, it worked quite reliably. I updated to FW3.3.0 today and tried again. Instead of the prompt to resume, I immediately got a "resuming print" message. It waited for the bed & nozzle to heat up, then moved the extruder into position. It is now stalled with a "Bed done" message. The extruder & bed remain at the correct temperatures.
Re: FW3.3.0-830 - Does not recover from power failure
I suggest posting this on the GitHub page, so the devs can take a look
https://github.com/prusa3d/prusa-firmware/issues
Anything can be made better
https://www.myminifactory.com/users/Joe%20Prints
Re: FW3.3.0-830 - Does not recover from power failure
I've entered the issue on github. I hate to bug the devs if this turns out to be an issue on my end. I really do miss the ability to resume on power outages though.