Notifications
Clear all
Failing supports with PRUSAMENT Vanilla White
Hello,
I've had some trouble with clogging reccently, but that seems to be resolved now (still keeping my fingers crossed). But now, I see failing supports on the 36hours print which is running right now:
On the picture, you can see how the rightmost support starts fine, but as it gets higher, it starts to oscillate and gets very weak. I paused the print, stabelized it with some hot glue and a piece of wood, now it's fine again.
I didn't have that trouble with galaxy black or silver filament from Prusa...
How can I avoid such failling supports in future prints (besides avoiding Vanilla White)?
This topic was modified 4 years ago by The Grue
Posted : 28/09/2020 1:42 pm
RE: Failing supports with PRUSAMENT Vanilla White
Defintely poor extrusion. I am not sure why it just this support.
--------------------
Chuck H
3D Printer Review Blog
Posted : 29/09/2020 12:44 am