Z axis gets stuck and shows wrong height - Assembly and first prints troubleshooting https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-assembly-and-first-prints-troubleshooting/z-axis-gets-stuck-and-shows-wrong-height/ Prusa3D Forum Discussion Board en-US Tue, 09 Jun 2026 09:27:15 +0000 wpForo 60 Z axis gets stuck and shows wrong height https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-assembly-and-first-prints-troubleshooting/z-axis-gets-stuck-and-shows-wrong-height/#post-692325 Tue, 02 Jan 2024 20:57:07 +0000 Hi everyone,

 

My mk3s+ has been acting up lately. when I do a color change or at the end of some prints what happens is the Z axis maxes a tiers noise and doesn't move whereas it should have moved, e.g. 58mm. I tried rebooting my printer and flashing the firmware but nothing is resolving this issue. Any Ideas?

 

 

]]> Assembly and first prints troubleshooting Rocket printer https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-assembly-and-first-prints-troubleshooting/z-axis-gets-stuck-and-shows-wrong-height/#post-692325