Notifications
Clear all
XYZ Calibration failed. Please consult the manual.
Did a few benchmarks after putting together my mk3s+. Half a year has passed since then. For the most part it's just been sitting where I built it and then moved into a different room.
I have readjusted the pinda sensor and updated the firmware to 3.12.2.
Posted : 08/07/2023 3:09 am
The three common reasons for errors after a printer has been unused for a while:
General neglect, dust and cobwebs... Basic cleaning, lubrication and general maintenance have all been missed. See: https://help.prusa3d.com/en/article/i3-printers-regular-maintenance_2072
Then once you have it working:
A dirty print bed. Give it a really thorough clean and avoid touching the print area.
Damp filament. Look up threads here about drying filament especially if it has been left open.
Cheerio,
Posted : 08/07/2023 1:11 pm