XYZ calibration failed.Bed calibration point was not found.
 
Notifications
Clear all

XYZ calibration failed.Bed calibration point was not found.  

  RSS
Oddisen
(@oddisen)
New Member
XYZ calibration failed.Bed calibration point was not found.

Hi i have a MK3 With firmware 3.8.1 
Do the selftest everything is ok 
But when i do the XYZ calibration i get this Messages 
"XYZ calibration failed.
Bed calibration point was not found"

Publié : 14/04/2020 10:46 am
newdragone
(@newdragone)
New Member
RE: XYZ calibration failed.Bed calibration point was not found.

Check this out: https://help.prusa3d.com/en/article/xyz-calibration-mk3-and-mk3s_112351

Publié : 14/04/2020 11:10 am
Partager :