Notifications
Clear all
Whistle first print question
I just finished building a new i3 mk3 and completed the calibration. I printed the whistle using the gcode from the SD card, using the included Prusa gray PLA.
The first layer left a lip around the edge of the whistle. Does this look like my first layer is too low? Thank you!
Posted : 17/09/2018 5:12 am
Re: Whistle first print question
Could be an elephants foot, google it to find out.
Also print a first layer calibration test to determine whether you need to adjust the z level. Don't rely on the whistle.
Posted : 17/09/2018 5:25 am