Notifiche
Cancella tutti
Temp tower negative slopes curving up
Hi!
I printed a temp tower , using the pregenerated .gcode. The inverted slopes came out very ugly independently of temperature. Stock MK3S+, prusament PLA Viva la Bronze.
(The bed adhesion is ok, allthough it didn't print to the end, as the upsloping catched on the nozzle, I guess, so it fell over before finishing)
Some of the filament has blackened, like it stays blocked in the hotend for a while?
What could it be?
Postato : 23/08/2022 12:01 pm
Topic starter
answered:
RE: Temp tower negative slopes curving up
Same, but less important with Rosa 3D PLA. 
Postato : 23/08/2022 7:12 pm