Notifications
Clear all
Skipping in extrusion?
Hi all,
I just finished the assembly of my MK3S four days ago. It's been printing well so far. I've been printing exclusively in PETG. However, I've noticed there's a skipping or breakage in one of the latest prints I've attempted.
Does anyone know what this may mean or what I should look at addressing?
The filament is Prusament PETG.
This topic was modified 5 years ago 2 times by r4yne
Posted : 29/04/2020 5:33 am
RE: Skipping in extrusion?
It's a bit hard to see in your picture, but it looks like you need to lower the nozzle a little bit further.
On your first layer it looks like there are gaps in the surface. A good first layer should have no gaps at all.
Bear MK3 with Bondtech extruder
Posted : 01/05/2020 7:45 am