Notifications
Clear all
Printing Issues
I had an issue this morning where a model was badly sliced and caused plastic to pool up around the extruder nozzle. After clearing/cleaning everything up, I reran the calibration and got everything set up right.
I then tried to do a quick print of some spool parts and it wasn't going well. See the attached images.
I'm new to the hobby so still learning 🙂
Posted : 26/06/2021 2:03 am
RE: Printing Issues
That looks like poor adhesion due to fingerprints on the plate.
Clean the sheet with dishwashing detergent (Dawn/Fairy) and plenty of HOT water, rinse well and dry with a fresh paper towel. Handle by the edges only.
Cheerio,
Posted : 26/06/2021 3:53 am
Mkauley and Dan Rogers liked